outlet conditions

In low mass flux and high outlet quality conditions, experiments have been performed using vertical heated tube, cooled by water, to determine CHF value for a uniformly heated section.

针对低流量高含汽量工况，本论文试验在长度为2.1m，管径为0.014m的均匀受热圆管中得到93组CHF数据。

Besides, downstream flow is stimulated due to the outlet conditions of DME flow inside the nozzle, to verify the simulation.

此外，本文还根据二甲醚喷孔内部流动计算所得的出口条件进行了下游流动的模拟，并对模拟进行了实验验证。

Blow-down tests of quarter-annular, semi-annular and full-annular cascades were performed under two different outlet conditions.

对1/4环、半环和全环形叶栅在两种出口条件下进行了吹风实验。

Application of the free molecule point source model to the plume field with nonuniform outlet conditions

自由分子点源法在非均匀出口羽流场模拟中的应用

The loop uses high-temperature helium as the thermal source and in full scale to simulate the 30% generator load for two-phase flow stability verification test under various conditions: inlet sub-cooling degree, outlet steam pressure, flow rate and inlet resistance.

实验系统用高温氦气作为热源，采用1∶1全尺寸模拟，进行了30%负荷工况两相流稳定性验证实验、入口过冷度、蒸汽出口压力、流量及入口阻力对两相流稳定性影响的研究。

Investigation of the inlet and outlet boundary conditions in numerical simulations of twin-screw extruders

双螺杆挤出机流场数值模拟中流道进出口边界条件的探讨

Excavation and Contruction of the Large Cross-section Outlet Section with Unfavourable Geological Conditions of the Tailrace Tunnel for the Stage ⅱ Guangzhou Pumped-storage Power station

广蓄二期工程尾水洞出口不良地质段大断面开挖施工

Adopting break point chlorination and managing related factors conditions made the concentration of ammonia nitrogen in outlet water significantly less than the national standard.

控制折点氯化法工艺条件，出水氨氮明显低于国家排放标准。通过焦炭有效去除水中余氯，达到安全排放。

The 3-D transient internal fluid of the exhaust manifold has been simulated with the inlet and outlet boundary conditions calculated by the thermodynamics.

通过热力学计算得到排气歧管的入口和出口边界条件，计算排气歧管的三维瞬态内流场；

The precision of the numerical simulation depends on the inlet and outlet boundary conditions as well as the turbulence model more than the grid refinement level and the grid type.

结果表明，相对于网格数目和网格类型，进、出口边界条件和湍流模型对计算和实验结果吻合的影响要大。

Under all experimental conditions the moist air at the humidifier outlet has very high relative humidity to nearly approach or attain the saturation.

在各实验工况下，湿化器的出口湿空气都具有很高的相对湿度，达到或接近饱和状态。

Uniform inlet flow and thermal conditions are specified to consider the effects of entrance region. Calculated stream velocity profiles at outlet are well agreed with analytical solutions.

给定均匀来流和温度边界条件以考虑进口处流动及温度边界层未发展的影响，计算得到的出口流速分布与充分发展的圆环管Couette流动的解析结果相一致。